Trail Master Suspension TM3330-40013 JEEP WRANGLER 4 DOOR (JK) 3 SPACER KIT - Manual (Page 6)

6
14. Install the front brake line drop (35-TM20010) to
the OE hole in the frame using the previously
removed OE hardware.
15. Reconnect the front brake line to the front brake
line drop (35-TM20010) using the supplied
5/16” X 1” bolt and hardware.
16. Reinstall the front track bar to the axle using the
previously removed hardware.
17. Reattach the transfer case skid plate using the
previously removed hardware. Torque the hard-
ware to
87 ft./lbs.
18. Reinstall the wheels and lower the vehicle to the
ground. Torque the lug nuts to factory specifica-
tions.
19. Torque all bolts to factory specifications. Re-
torque all bolts after 500 miles.
Prepare to Install Rear
Suspension
1. Jack the rear of the vehicle with the floor jack
under the differential and place jack stands un-
der the frame just in front of the lower control
arm frame mounts. Leave the jack stands high
enough to let the floor jack down and still have
the rear tires suspended in the air. Keep the
floor jack under the differential with slight pres-
sure for support.
2. Remove the rear wheels.
3. Unbolt and remove the rear track bar from the
vehicle. Save the hardware for reuse.
4. Disconnect the rear emergency brake line
bracket from it’s mounting stud. Save the hard-
ware for reuse.
5. Unbolt and remove the rear shocks from the ve-
hicle. Save the hardware for reuse.
6. Unbolt the lower sway bar end links. Save the
hardware for reuse.
7. Unbolt the brake line bracket from the frame.
Save the hardware for reuse.
8. Unclip the ABS line from the axle.
9. Lower the rear differential so that the springs
come loose. Remove the OE coil springs and
the OE isolators. Label the springs as to which
side they were removed, Left and Right so that
they are reinstalled in the side in which they
were removed.
Install Rear Suspension
1. Install the passenger side track bar drop bracket
(82-TM20011) into the upper track bar mounting
position using the previously removed OE bolt,
hardware and sleeve (35-TM30010).
35-TM20010
Front Brake
Line Drop
OE bolt
5/16” X 1”
bolt
Rear Upper
Coil Pocket