Trail Master Suspension TM402_TM402N 2009– 2013 FORD F-150 2WD ONLY 2 1/2 FRONT SPACER KIT - Manual (Page 6)

TM402 &
TM402N
Revised
8.9.13
6
22. Using the rear outer hole in the bracket as
a guide, drill through the A-Arm pocket
using a 3/8” drill bit. Secure using the
3/8” X 1” bolt and hardware. Torque the
3/8” and 1/2” hardware according to the
torque chart on page
3 .
23. Reinstall the ground cable and bolt using
the previously removed OE hardware.
24. Repeat steps 5 through 24 on the remain-
ing side of the vehicle.
25. Reinstall the front wheels.
26. Now would also be a good time to inspect
the rear shocks for damage or fluid leak-
age. Replace if necessary.
IMPORTANT! BE SURE TO BRING
THE VEHICLE IMMEDIATELY TO A
REPUTABLE ALIGNMENT SHOP TO
BE ALIGNED!
27. Torque all bolts to factory specifications.
Re-torque all bolts after 500 miles.
1/2” X
1 1/4”
Bolt
Ground
Cable
Bolt
Drill 3/8” Hole
Secure Using
3/8” x 1” Bolt
15-11018
Bump Stop
Front Upper
A-Arm
Mounting
Pocket
Front of Vehicle
Bump Stop
94-5456
drvr and
94-5459
pass