T-Fal Ultraglide Easycord - Manual (Page 8)

3
• Adjust the temperature (see table below) by turning the temperature
control dial to the temperature select position ( fig. 5 ).
• When the iron is plugged in, the temperature control light will remain
“on” until the temperature is reached ( fig.6 ). Once the temperature is
reached, it will go “off”.
• Adjust the amount of continuous steam output by moving the steam
control lever ( fig.7 ). See below table for recommended steam output
levels.
To adjust the temperature and the steam
- It is normal for the
temperature indicator light to
turn on and off during ironing.
- In order to avoid water leaking
from the soleplate onto your
garment:
• Set the steam lever to
when ironing silk or
synthetic fabrics and set it to
for wool.
• Should you need to turn
down the temperature, wait
until the temperature light
comes back on before
beginning to iron again.
- When ironing fabrics with
mixed fabrics, set the iron
temperature for the most
delicate fabric.
- For delicate fabrics, we
recommend testing the fabric
first on an inconspicious place
for example, inside the hem.
- If you want to iron without
steam, set the steam control
level to
.
• Your iron heats up quickly, therefore, begin ironing with fabrics that are
ironed at lower temperatures first, then go on to those requiring a
higher temperature.
F ABRIC
P OSITION OF
TEMPERATURE BUTTON
S TEAM SETTING
POSITION
L INEN MAX
C OTTON •••
W OOL ••
S ILK
• S YNTHETIC
(Polyester, Acetate,
Acrylic, Polyamid)
To obtain more steam
• Press the Burst of Steam button periodically to remove stubborn
wrinkles ( fig.8 ).
In order to achieve the
maximum amount of steam, it
is recommended that you wait a
few seconds after you push the
burst of steam button again.
= STEAM ZONE
• Your iron is equipped with the Easycord system to prevent the cord
from dragging across your garments and wrinkling just ironed
clothing.
• Press the button located on the base ( fig.4 ) and the Easycord system
is automatically in use. You can now plug in your appliance and begin
ironing.
Always use the Easycord
system for enhanced comfort
of use.
To use the Easycord system
Use
• Unplug your iron before filling it and set the steam control lever to
( fig.1 ).
• Open the water tank filling inlet lid ( fig.2 ), place the iron in a
horizontal position and fill it with water ( fig.3 ).
• Close the water tank filling inlet lid.
To fill the water tank
Do not exceed the “MAX” fill
level as indicated on the water
tank of the iron.
1800123494 FV42XX-FV43XX FTD US_110x154 20/06/11 16:24 Page3