Specifications – Classe Audio CA-2200 User Manual
Page 28
28
Specifications
All specifi cations are accurate at the time of printing. Classé reserves the right to
adjust specifi cations without notice.
Power output
200W/ch continuous rms @ 8Ω
(both channels driven)
400W/ch continuous rms @ 4Ω
Frequency response
10Hz – 22kHz (+0/-0.1dB)
10Hz – 155kHz (+0/-3.0dB)
Phase
better than -10° @ 22kHz
Signal-to-noise ratio 108dB
(ref. full ouput, 10Hz – 80kHz)
Channel separation
better than 110dB @ 20kHz
Noise floor (FFT)
all peaks less than -95dBV
(10Hz – 80kHz)
Distortion (THD + noise)
0.003% @ 8Ω
(unweighted, 1.0Vrms/1kHz input, 10Hz – 500kHz)
Voltage gain 29.1dB
Sensitivity
1.4Vrms for rated output @ 8Ω
Input Impedance 100kΩ
Rated power consumption (as per IEC60065 para. 2.3.10) 480W
Idle power consumption 166W
Mains voltage specifi ed on rear panel
(cannot be changed by dealer or user).
Dimensions (not incl. controls or connectors)
Width: 17.5” (445mm)
Height: 8.75” (222mm)
Depth: 18.5” (470mm)
Shipping weight 92lbs
(42kg)
Net weight 80lbs
(36kg)
For more information, see your Classé dealer, or contact:
Classé Audio
5070 François Cusson
Lachine, Quebec
Canada H8T 1B3
Telephone +1 (514) 636-6384
FAX
+1 (514) 636-1428
Internet:
http://www.classeaudio.com
email: [email protected]
Classé and the Classé logo are trademarks of Classé Audio Inc. of Lachine, Canada. All rights reserved.
i-Command™ is a trademark of Equity International, Inc. All rights reserved.
AMX® is a registered trademark of AMX Corporation of Richardson, TX. All rights reserved.
Crestron™ is a trademark of Crestron Electronics, Inc. of Rockleigh, NJ. All rights reserved.