Stealth Cam STC-DVIR8 Sniper-IR - Manual (Page 15)

STC-DVIR8
www.stealthcam.net Toll Free 877-269-8490 15
Programming the Stealth Cam
Switch the camera to the ON position. LCD screen will display the
camera status screen. Press the MENU button within 30 seconds to
enter programming mode.
If MENU button is not pressed within 30 seconds, camera will
automatically enter PIR detection mode.
Set the Resolution: The first program setting is resolution.
• The word RESOLUTION will be blinking.
• Press [OK] button to choose the selection.
• Press the [UP] or [DN] button to select the desired resolution
(HIGH/LOW/BASE) and press [OK] to save and exit to
CAPTURING setting.
Set the Capturing sequence. Your Stealth Cam can be
programmed to shoot 1~9 pictures per triggering.
•
The word CAMERA will be blinking.
• Press [OK] button and the number of burst mode will now blink.
Press the [UP] or [DN] button to select the desired burst mode
setting (number of pictures per triggering).