CompuSTAR 2WSHR LED - Manual (Page 6)

The only feature that operates in valet mode is the keyless entry function.
Valet Mode is very useful when loaning your
vehicle or having it serviced.
In order to enter Valet mode, press Buttons
( + ) simultaneously for a 1/2 second.
In order to manually enter Valet Mode, insert your
car key into the ignition and turn the ignition on and
off (between ACC and ON) five times within 7 seconds
You can exit Valet Mode only by pressing buttons ( + )
simultaneously for a 1/2 second.
Valet Mode
9
Safety Shut Down Features
Compustar 2WSHR LED system has several shut down safety features.
The following actions will shut down the engine or prevent the car from auto-
starting: Opening the engine hood, Pressing the brake or Valet mode
is turned on.
The optional RPS is a feature that allows an individual to page the owner of a
vehicle by simply tapping on the front windshield of the car. RPS is automatically
turned on upon activating alarm mode (pressing the button for a 1/2 second)
on the Compustar 2WSHR LED,
The RPS module can be activated by tapping a manual key producing a
high-frequency vibration. This high-frequency vibration is detected and your
remote-pager will beep and
all of the icons will flash.
RPS (Remote Paging System)
OPTIONAL PROGRAMMABLE FEATURES
These additional programmable features can be programmed to the Compustar
system by your authorized CompuStar dealer.
Passive Arming
10
You can turn this function on or off by pressing the buttons ( + ) for
a 1/2 second. When set to passive arming, your security system will arm
automatically 30 seconds after all the doors are closed. There are two types
of passive arming that can be programmed by your Compustar dealership:
(1) passive arming with passive lock and (2) passive arming with active lock.
Passive locking means the door will lock when the system passively arms.
In the default factory setting, the system is armed and locked actively, which
means the system will only arm/lock when the remote-pager is utilized.
Note :
1. If you select both Auto Arming and Passive Arming, Auto Arming
takes priority over Passive Arming.
2. If you select Passive Arming with Active Lock in the programming
option, you are also selecting Auto Arming without Auto Lock.
Consult your installer.
Ignition Lock
This programmable option enables your vehicle to automatically lock the doors
when the brake pedal is pressed after starting the vehicle with a key.
In addition, the vehicle will automatically unlock the doors upon pulling the key
out from the ignition. However, if the emergency brake wire was installed, the
vehicle will unlock upon the emergency brake is set if the engine is still running
with the key. This option must be chosen at the time of installation.