Crown Boiler CLBR68-112L User Manual
Crown Boiler Stoves

Instructions for Installation and
Connection of Oil Burner to Furnace
For Furnace Models:
CHB68-112L
CHC68-96L
CLBF68-112L
CLBR68-112L
: Failure to follow these instructions exactly may result in a fire or
explosion causing property damage, personal injury or loss of life.
DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of
this or any other appliance.
What to do if you find an oil leak:
• DO NOT try to operate this appliance.
• If possible, close the manual fuel shutoff valve on the oil supply tank.
• Immediately call your oil supplier. Follow the oil supplier’s instructions.
• If you cannot reach your oil supplier, call the fire department.
A qualified installer, service agency, or the oil supplier must perform installation and
service.
These instructions should be:
• read prior to installation.
• retained for qualified service personnel
•
reviewed before performing any service or maintenance.
Crown Boiler Company
3633 “I” Street
Philadelphia, Pennsylvania 19134
MO-432
ECN4514-MA
Document Outline
- CHB68-112L CHC68-96L CLBF68-112L
- CLBR68-112L
- ? CAUTION:
- ONLY a qualified oil-heating contractor shall install and adjust this oil burner, using calibrated combustion test instruments, to ensure safe and reliable operation of the furnace.
- ONLY two (2) oil burner models shall be used with the Crown furnaces,
- R.W. Beckett model AF specification number EFL-102, or
- Carlin Combustion model EZ1-HP specification number 10250.
- This furnace has been tested and approved for use when burning No. 2 distillate fuel (home heating) oil ONLY.
- Introduction:
- These instructions list the steps required to field install a R.W. Beckett or a Carlin Combustion oil burner assembly in any of the Crown oil-fired furnace models previously noted. The factory ships all Crown furnace models without the oil burner install