ConvaTec USA 900EC - Manual (Page 8)

5.0 DIAGNOSTICS & REPAIR
PROBLEM CAUSE SOLUTION
No functions operate No power to unit Check power cord
Is it plugged into receptacle?
Green Power-on light Electrical power cord not
does not glow properly plugged into Check cord for breaks.
control module
Power cord plugged Check for power to receptacle
in but no functions
operate Bad handset Replace handset
Bad control module Replace control module
6.0
CLEANING & MAINTENANCE
The chair is subject to wear and tear resulting from the place, length, and other conditions of use.
For longer use, periodically inspect all parts and have them replaced as needed.
• check the cushions for rips or tears
• check operation of the brake pedals
• check set screws on brake pedals
• check all bolts and nuts for tightness
Your maintenance department should inspect the chair periodically ( at least every 6 months) for
proper operation.
Every six months minimum:
• lubricate all slides and pivot points with FDA approved light grease
• check all electrical wiring for any frays, kinks and or deterioration
• ensure that lock and steer castor operate properly
Any discrepancies noted during inspection must be corrected before using chair.
CLEANING
Any ?uid spilled on the seat, back or leg cushions should be removed as quickly as possible.
All painted metal surfaces should be wiped with a clean, soft cloth weekly.
All moving parts should be lubricated occasionally with light approved oils to help insure quiet,
dependable operation.
Before using any cleaning product, test it on the underside of the chair seat. Never use any vola
tile ?uid (thinner, gasoline, etc) that could cause discoloration or deterioration.
Use mild soap and water or a nonabrasive hospital grade detergent disinfectant to clean the chair.
First, wet a cloth with the cleaning product and wring it dry, then gently wipe off the chair.