Revel M8 - Manual (Page 5)

Operation
Surround Modes
When using the system in a Dolby ® Digital or DTS ® home
theater system, make sure the receiver or processor is
set to “Small” for all M8 loudspeakers.
Some receivers/processors offer a choice of crossover
frequencies. Select 110Hz as the crossover frequency for
all M8 loudspeakers in the system.
Some Dolby Digital-equipped receivers/processors offer
different setup options for each source or surround
mode, e.g., CD-stereo, DVD, Dolby, Pro Logic.
® In each
case, follow your equipment’s instructions to ensure that
the subwoofer output is turned on and that the speakers
are set to “Small” or to a crossover frequency of 110Hz
in each mode.
Maintenance
and Service
The satellite enclosure may be cleaned using a soft cloth
to remove fingerprints or to wipe off dust.
All wiring connections should be inspected and cleaned
or remade periodically. The frequency of maintenance
depends on the metals involved in the connections,
atmospheric conditions and other factors, but once
per year is the minimum.
If a problem occurs, make sure that all connections
are properly made and clean. If a problem exists in one
loudspeaker, reverse the connection wires to the left
and right speakers. If the problem remains in the same
speaker, then the fault is with the loudspeaker. If the
problem appears in the opposite speaker, the cause is
in another component or cable. If your M8 loudspeaker
should ever need service, please contact your local
dealer or distributor, or visit www.revelspeakers.com
for the location of a service center.
5
HSGP1051-M8_OM 9/12/08 12:09 PM Page 5