Replay XD XD720 - Manual (Page 6)

1. Find the best mounting location for your Replay XD720 and check your angles.
Rigid surfaces are ideal for the best video quality. Note: You can make a test recording and
check it on an iPad/Mac/PC.
2. Flip LowBoy mount upside down and carefully spread, insert Replay XD720 into
holder with buttons passing through the cut-out.
3. With the Replay XD720 centered in LowBoy mount, rotate 360º to desired rotation.
4. Slide LowBoy mount into SnapTray until it is fully seated and clicks. The LowBoy mount has
rubber strips to hold your Replay XD720 from rotating when seated, make sure your rotation
angle is ideal. You can make fine adjustments by sliding the LowBoy in/out of the SnapTray.
5. Attach VHB SnapTray adhesive mount to a clean smooth surface.
The 3M VHB adhesive is not recommended for textured surfaces.
LO W BOY M O U N T See our full range of mounts at www.Replayxd.com
VHB SnapTray LowBoy Mount
Unlock
Lock
IMPORTANT
Use rubbing alcohol to clean
the mounting surface. Wipe
dry the surface. Apply your
VHB mount to surface. Press
and hold for sixty seconds to
allow adhesive to bond to
the surface. Bond strength
will increase through time.
At room temperature,
wait for at least 24 hours
to achieve 90% bonding
strength, and 72 hours for
100% bonding strength.