Reloop KEYPAD - MIDI Editor Guide - Manual (Page 2)

v 1.0 MIDI Editor
MIDI Editor GUIDE
Firmware Update
In order to use the MIDI Editor it is necessary to update the Reloop Keypad / Keyfadr with the latest firmware
To update your device, you will find the updater.exe and firmware file within the downloaded package
Please proceed with the following steps:
1. Connect the the Reloop Keypad / Keyfadr via USB to your computer
2. Run the included update.exe and be sure the Keypad.led / Keyfadr.led file is
within the same folder
3. Follow the steps on screen and press any button
4. Un-plug the device and re-plug it again. The device is now in firmware upgrade mode
5. Open the updater.exe again and the update will proceed
>> Once finished close the updater window by hitting any key
> DOWNLOAD FIRMWARE & MIDI EDITOR: http://www.reloop.com/reloop-keypad#download
Troubleshooting
• If the updater.exe does not proceed while upgrading, please redo the steps above
• If any „device port name can‘t be found“ please be sure all other programs are closed and all virtual MIDI ports are
closed/uninstalled (e.g. MIDI Yoke / Bome or else)