LaserLyte CK-MS - Large Rez Size - Manual (Page 2)

Trigger Guard Laser for the Bersa Thunder .380 & .380 Plus
1
2
3
CK-MS
Installation:
•
UNLOAD FIREARM.
•
Attach danger label to side of gun near laser with arrow pointing
toward front sight.
•
DO NOT TOUCH THESE SCREWS. (Figure A)
Place each side of CK-MS laser on front of trigger guard
(battery cover on right).
Insert four attachment screws from left side as shown. Tighten
down until snug with the .050 hex key provided. With same hex key,
tighten down battery cover. Do not over tighten battery cover, and
check periodically.
When properly installed, the Disassembly Lever will glide easily
past the laser.
* Read instructions completely before installing your laser.
Failure to do so may result in damage to your laser or firearm.
L ASER L YTE L ASER L YTE
BERSA
1
3
•
UNLOAD FIREARM.
•
Attach danger label to side of gun near laser with arrow pointing
toward front sight.
•
DO NOT TOUCH THESE SCREWS.
(Figure A)
RIGHT
SIDE
LEFT
SIDE
BERSA
2
L ASER L YTE
L ASER L YTE
BERSA
L ASER
L YTE
LASERLYTE
5 sec.
1
1 2 3
2
3
Activation: CK-MS laser has ambidextrous activation.
Press once turns laser on: constant or pulse.
Press and hold for 5 seconds to change mode.
Second press turns laser off.
1
1 3
2
2
3
Laser Sight In:
Use the provided .035 hex key to adjust the sight.
Always end adjustments on a clockwise turn.
Make final adjustments at shooting range.
Moving
Laser
Dot
right
left
Windage
or
ON/OFF
LASERLYTE
LASERLYTE
L ASER L YTE
ON/OFF
ON/OFF
or
ON/OFF
LASERLYTE
LASERLYTE
ON/OFF
up
down
Elevation
L ASER L YTE
L ASE R L YTE
BERSA