LaserLyte LBS-HULK-140 - Low Rez Size - Manual (Page 2)

UNLOAD FIREARM! Insert bore tool into the shotgun adapter and thread into screw.
Put into shotgun barrel.
Hold shotgun adapter and twist the bore sighter until a snug fit.
Once snug follow instructions for Sight-In steps.
1
2
3
1
2 3
4
Shotgun Adapter
BAK-1220-300
Laser
line
Scope view
before
Scope view
after
Center
Bubble
3 Yards/Meters
1
3
5 6
2
4
WARRANTY:
One year
limited warranty
DANGER
LASER LIGHT
AVOID DIRECT EYE EXPOSURE
POWER OUTPUT < 5mw
WAVELENGTH 630-670mm
CLASS IIIa PRODUCT
®
A Division of P&L Industries
www.LaserLyte.com
101 Airpark Road
Cottonwood, AZ 86326
Phone 928-649-3201 -
Fax 928-649-3970
20 Gauge
(.510 -.625 Caliber)
12 Gauge
(.625 -.750 Caliber)
Twist the laser to open.
Unscrew end from body & cup. Remove the battery.
Replace battery. Insert with positive (+) going into cup.
Screw the end back into cup & body of the bore tool.
1
1 2
4
2
3
3
4
Battery Replacement:
(1) CR2 Battery
UNLOAD FIREARM! Secure firearm in a rest and make level.
Follow 1-3 Sight-In Steps.
Put the adapter with ring over the end of the bore tool.
Adjust bubble between the two lines.
Turn on laser and shine on wall 3 yards/meters away.
Adjust cross hairs until they are parallel with red laser line.
Tighten down scope rings, pull off scope leveler and proceed to Sight-In steps.
Scope Leveler Adapter
Gun Leveler
SLA-001-140
+
1
2
3
4
5
6
7
Top View
Slide gun leveler onto top scope rail.
Use the bubble level and adjust gun so bubble is between lines.
Secure gun, mount scope and follow scope leveling directions.
1
1 2
2