LandAirSea GPS Tracking Key Pro Troubleshooting Guide User Manual
Landairsea tracking key troubleshooting guide

LandAirSea Tracking Key Troubleshooting Guide
Problem
Cause
Solution
Error message reads –“LAS 3
series device not found”
• Low battery power.
• Drivers are not
installed.
• Check Battery Indication Light and replace the
batteries
• Plug in the unit to your USB Port. Go to your
Control Panel Æ System Æ Click the
Hardware Tab Æ Device Manager. Find the
Item called Ports and double click it. The
Tracking Key will be listed there. If you do not
see it, then restart your computer with the
tracking key plugged in. If it is listed with a
yellow exclamation mark right click it and select
Uninstall, after which reboot your computer.
Then follow the instructions in the Software
Installation Quick Start Guide.
Cannot Find the USB Plug,
Power Switch, or Battery
Compartment
• No Cause
• There is a rectangular protective cap that is
snapped in on the front of the unit. Pull on this
cap to expose the USB Plug
• There is no power switch on the LandAirSea
Tracking Key. Once you place batteries in the
unit, it will be ON. To turn the unit off, remove
the batteries or within 3 minutes and the unit
will enter sleep mode (Note: the Green LED will
not turn off when in sleep mode).
• You will see the control panel under the
rectangular cap. The battery compartment is
opened by removing the 4 screws on the bottom
of the unit.
Error message reads –
“Memory Empty- No
downloadable data.”
• Placement with in the
vehicle.
• Low battery power
• Double check your placement, and move if
necessary. The GPS indication light will flash
when there is a good GPS lock.
• Replace the batteries.
Red battery indication light or
the light turns off right away.
• Low battery power.
• Replace the batteries
Gaps within the Data
• Placement with in the
vehicle.
• GPS lock on time.
• Low battery power.
• Double check your placement, and move if
necessary. The GPS indication light will flash
when there is a good GPS lock.
• After elongated stops it may take your device 2-
3 minutes to lock back on to the GPS satellites.
• Replace the batteries
No Maps, Google Earth won’t
run properly, or erratic data.
• Windows 98 operating
system is being used.
• System is out of date
• Bad tracking data.
• Contact
for the
walkthrough on how to fix this problem.
• Double check Google Earth system
requirements and upgrade if necessary.
• Reposition your device in the vehicle, erase the
data that you have off of your unit and gather
some new data.
No Power
• Low battery power
• Possible damage.
• Replace the batteries
• Contact
for further
assistance.
Please Contact
if any problem persists.