Klimaire KTHM015-E5H2 PTAC Installation Manual - Manual (Page 10)

9
CARE AND CLEANING
FRONT PANEL AND CASE
- Turn u nit off and discon nect power supply.To clean,
use water and a mild detergent. use bleach
and abrasivers.Som e commercial cleane rs may
damag e the plastic parts.
DO NOT
- Rem oving Air Filter
Fig.9
OUTDOOR COIL
- Coil on outdo or side of unit shou ld be checked
regularly.Unit will ne ed to be remo ved to inspect
dirt bu ild-up that will occur on the inside of the coil.
If clogge d with dirt and soo t ,coil should be
professionally cleaned. Clean inside a nd out side of
outdoor coils reg ularly.
Never use a hig h-p ressure sp ray on coil. NOTE:
!
CAUTION
F ailure to follo w th is cau tion may result in
equipm ent damg e or imp roper o peration.
Airflow restriction ma y ca use da mage to the u nit.
UNIT DAMAGE HAZARD
AIR FILTERS
IMPORTANT:TURN UNIT OFF BEFORE
CLEANING.
- The m ost important thing you can do to ma intain
unit efficiency is to clean th e filters once every
two weeks as requ ired.
Clogged filters reduce cooling,heating and airflow.
!
CAUTION
Failure to follow this caution may result in
equipm ent damge or improper operation.
operate unit without filters in place.If a filter
becomes torn or dam age d,it should be rep laced
imm ediately.
Operating without filters in place or with damaged
filter will allow dirt and du st to reach ind oor coil and
redu ce cooling ,heating,airflow and efficiency of unit.
Airflow restriction may cause da mage to unit.
Do not
UNIT DAMAGE HAZARD
-
Decrease cost of op era tion.
Save energy.
Prevent clogged ind oor coil.
Reduce risk of prem atu re com ponent failure.
Keeping filters clean will:
-
Vacuum off heavy soil.
Run water throug h filter.
Dry tho roughly before replacing.
To Clean Air Filters:
Pull up
2 Air filters
- Replacing Air Filter
Fig.10
Push do wn
VENT DOOR FILTER
IMPORTANT:TURN UNIT OFF BEFORE
CLEANING.
- If the vent door is o pen,access requires the rem oval
of the un it from the wall sleeve.C lean th e vent filter
twice a year or as required.
- Make sure to remo ve the shipping screw from the
ve nt d oor.(See.F ig.5)
- Rotate the vent control lever to o pen the ve nt door.
(See. Fig .6)
- Remo ve four screws from the ven t door filter.
(See .Fig .11)
- First pull out the ven t d oor steel w ire from th e hole
of the ven t do or, the n take off the ven t d oor and filter.
(See.Fig.11)
- Clean the filter.Dry thoroughly before re placing.
- Replac the vent door and filter,re install the four
screws.
- Reinsert the vent do or ste el wire into the ho le of the
ve nt d oor.
.
Vent door
control lever
Vent door
steel wire
Vent door
filter
Screws
F ig.11 Vent door