JK Audio QuickTap IFB - Manual (Page 4)

4
FAQ’s
? What kind of earpiece should I use with the
QuickTap IFB?
! Any standard earpiece should work fine as long
as it has an impedance greater than 600 ohms.
? I want to send the QuickTap IFB's XLR out-
put to an auxiliary input of my mixer but I'm
not getting any audio. What's wrong?
! The QuickTap IFB is a passive device that out-
puts a mic level signal. You'll need to send the
output to a mic input on your mixer.
? How do I adjust the level of the XLR output
on my QuickTap IFB?
! The attenuator on the QuickTap IFB only ad-
justs the 1/8" earpiece jack. The male XLR pro-
vides a fixed level 600 ohm output.
? I'd like to use a pair of headphones with my
QuickTap IFB. Is this possible?
! The QuickTap IFB is a passive device and will
not power a pair of headphones. You'll need to
use a JK Audio RemoteAmp with it. The Re-
moteAmp will take the balanced output from the
QuickTap IFB, amplify it and send it to a 1/4"
headphone jack and a 3.5 mm output jack.