JK Audio QuickTap - Manual (Page 3)

6
Your new JK Audio product has been registered with the
Federal Communications Commission (FCC). This
product complies with the standards in Part 68 of the
FCC rules. The FCC requires us to provide the following
information:
1. Connection and use with the nationwide
telephone network
The FCC requires that you connect this telephone
equipment to the national telephone network through
a FCC registered telephone.
This equipment may not be used with Party Line
Service or Coin Telephone Lines.
2. Information for the telephone company
Upon request from your local telephone company,
you are required to provide the following information:
a) The "line" to which you will connect the telephone
equipment (that is, your telephone number), and
b) The telephone equipment's FCC registration
number. This can be found on the bottom of your
telephone equipment.
3. Repair Instructions
If it is determined that your telephone equipment is
malfunctioning, the FCC requires that it not be used
and that it be unplugged from the modular outlet until
the problem has been corrected.
FCC Registration
3
Operation
The Output Jack provides a mix of both sides
of the conversation. In other words, whatever
you send down the phone line will come back
on this jack mixed with the audio from the other
side of the call.
Two adapter cables are supplied with the
QuickTap. One cable has 1/8" mono connec-
tors on each end. This cable can be used to
connect QuickTap to the line input on some
powered speakers.
The second cord has a 1/8" stereo plug on one
end and an RCA mono plug on the other end.
The RCA plug is wired to the tip or left channel
of the stereo plug. The ring or right channel is
not connected. Use this cable to connect
QuickTap to powered speakers or amplifiers
equipped with RCA jacks.