Bluetooth wireless technology, Bluetooth status led, When should i release the pair button – JK Audio Outerloop User Manual
Page 12
6
Outerloop
Wireless Intercom Beltpack
Bluetooth Wireless Technology
Bluetooth Status LED
The blue LED on the front of the unit flashes in different sequences to indicate the
current connection status. When attempting to put the unit into Pairing mode,
you should power the unit off then back on before pressing the Pair button.
If you put the unit into the wrong state due to releasing the button at the wrong
time, holding it again for "X" seconds will not put it into the desired mode.
When Should I Release the Pair Button?
Pairing Mode
Clear
Pairing Mode
Clear
Bluetooth LED
seconds
Headset Mode
Phone Mode
Idle Mode
Idle Mode
See also other documents in the category JK Audio Accessories communication:
- AutoHybrid - Telephone Audio Interface (16 pages)
- BlueDriver-F3 (24 pages)
- BlueDriver-M3 (24 pages)
- BlueKeeper (12 pages)
- BlueKeeper (24 pages)
- BluePack (24 pages)
- BlueSet (20 pages)
- Broadcast Host (20 pages)
- BSET-HS1 (11 pages)
- CellTap (8 pages)
- CellTap (4 pages)
- ComPack (8 pages)
- ComPack (16 pages)
- Concierge 2x6 (11 pages)
- Concierge 2x6 (10 pages)
- Daptor One (8 pages)
- Daptor One (4 pages)
- Daptor Two (4 pages)
- Daptor Two (8 pages)
- Daptor Three (6 pages)
- Daptor Three (12 pages)
- Four IFB (10 pages)
- Four IFB (20 pages)
- Guest Module 1 (5 pages)
- Inline Patch (6 pages)
- innkeeper 1x/rx (8 pages)
- innkeeper 1x/rx (16 pages)
- innkeeper 2 (20 pages)
- innkeeper 2 (10 pages)
- innkeeper LTD (10 pages)
- innkeeper LTD (20 pages)
- innkeeper PBX (20 pages)
- Interchange (16 pages)
- Interloop (24 pages)
- PBXport (8 pages)
- PBXport (16 pages)
- Pureformer (2 pages)
- Pureformer (4 pages)
- QuickTap (4 pages)
- QuickTap (8 pages)
- QuickTap IFB (4 pages)
- QuickTap IFB (8 pages)
- RemoteAmp (2 pages)
- RemoteAmp (4 pages)