GunVault GV 3000 - Manual (Page 3)

- 2 -
Getting Started
Set your keys to the side. Don’t lock them inside the safe!
● Pull open the battery cover.
● Pull out the battery holder, by gently pulling on the ribbon.
● Insert new 9v battery. Following the Positive (+) and Negative (-) guides on
the holder.
● When power has been connected, the green light blinks one time and then
the red light blinks one time, with a long beep during the process.
● Use the factory-default code to open the unit, which is: Press each button one
time, from left to right -- 1 , 2 , 3 , 4.
● Getting ready to program
● Find the LED light in the keypad.
● It can glow either green or red. Depending upon the function being utilized.
● There is an audible beep when keys are pressed.