GunVault GV 2000 - Manual (Page 7)

- 6 -
Notes:

Avoid programming in bright light; it might prevent you from seeing the red/green LED.

Look directly down upon the keypad.

Do not attempt to press the buttons with the safe resting upon a soft surface, such as a bed, a
pillow, or a deep pile carpet.
Programming Your Access Code
Note: There is a soft “beep” sound and a brief light with each keypad entry. Enter the factory-
default code, from left to right: one, two, three, four. The door will open. Leave the door open.
Find the Learn Button (see Pg 5).

Press and hold the Learn Button
for two seconds. You should see
the green light and hear the beep
– the unit is now in “Learn”
mode.

Enter your new code. The light
will remain green.

Press and hold the Learn button
again for two seconds. The light
will turn red, and you will hear a
beep. Release the Learn Button.

While the light is red, enter your
new code a second time to
confirm it.

Press and hold the Learn Button a third time for two seconds. Release the Learn button. The
light will blink green five times. And you will hear five beeps, confirming that the new code
has been accepted. If the red light blinks three times with three soft beeps at this point, and
error has occurred. Just start over by depressing the Learn Button for two seconds.
Turning Off Keypad Sound
To disable the Keypad Sound (beeps), press and hold the Learn Button for two seconds, three
times. The green light will blink three times and you will hear three beeps. Release the button.
Then press and hold buttons two and three for five seconds. The Keypad Sound is now disabled,
but this does not disable the alarm sound.
Tamper Detect Feature
Entering an invalid access code sets the tamper indicator.
Hold down buttons two and three for five seconds to read the tamper indicator.

If tampering has been detected, the red light will glow until buttons two and three are
released.

If tampering has not been detected, the green light will glow until buttons two and three are
released.