GBC Auto 50 MBM Crease - Manual (Page 21)

Absolute and Incremental Programming
The main difference between the two types of programming system is that Absolute
measurements are taken from the leading edge of the document, and Incremental
measurements are taken from the previous crease line.
Example.
A document requires three creases, the first is 100mm from the leading edge, the second
is 150mm from the leading edge and the third is 175mm from the leading edge as shown
below.
100mm 50mm 25mm
Front Edge 2
nd 1
st
To program this job in Absolute, all of the measurements are taken from the front edge,
1
st
crease at 100mm
2
nd
crease at 150mm
3
rd
crease at 175mm
To program with Incremental measurements, the first distance is taken from the front
edge, the second is taken from the first crease, and the third from the second crease.
1
st
crease at 100mm
2
nd
crease at 50mm
3
rd
crease at 25mm
3
rd
21