System two operating instructions – GBC Sys2 User Manual
Page 3

SYSTEM TWO
OPERATING INSTRUCTIONS
Binding
1. Begin the binding process by pulling the pressure bar toward you and lowering it
on top of the document. To prevent jamming problems, lower the bar onto the
document rather than "drop" it.
2. Press the bind button, and the ready indicator will flash. When the binding cycle
is complete, you will hear beeps and the ready indicator will be off.
3. Lift the pressure bar to its original position, and the ready indicator will
illuminate continuously. Remove the bound document.
4. IF THE BINDING CYCLE IS NOT COMPLETED, THE TRAY-FULL
AND READY INDICATORS WILL FLASH ALTERNATELY. Simply turn
the machine off and on, or, press either the Bind or Punch Button. Rebind the
document. If the binding cycle is incomplete again, call for service.
5. The Tray Full Indicator will flash after 50 binds. Remove the tray with the power
on, empty it, and reinsert it.