GBC Sys4b - Manual (Page 2)

4.0 OPERATING INSTRUCTIONS
4.2
Binding
1. Turn the machine on, and the "Wait" light will be on. The machine takes about
45 seconds to warm up, and the "Wait" light to go off.
2. Use the selector button to identify whether the document is less than or greater
than 1 inch (25 mm). The machine will automatically vary the binding speed to
make the most secure bind.
3. Begin the binding process by pulling the pressure bar toward you and lowering
it on top of the document. To prevent jamming problems, lower the bar onto the
document rather than "drop" it.
4. The binding cycle will start automatically, and the pressure bar will return to its
original position when the cycle is complete.
5. Remove the bound document.
4-2