Garden Sun Heater HSS-A-FXPC Ratton Square - Manual (Page 9)

9
ASSEMBLY INSTRUCTIONS
Hardware Used
EE
FF
GG
9
10-1
TT
9. WARNING:Remove protective cover before
assembling.
Note: If necessary for proper alignment of reflector
sections, loosen each bolt prior to further assembly
and retighten after sections are aligned.
10. 10-1.Slide two reflector panels together.
Insert one screw
0;))6OLGHRQHZDVKHUĭ
(EE) over threaded end of screw M6 X 10 (FF) and
screw on cap nut (GG) loosely.
10-2. Slide reflector plate onto reflector panels.
Insert one screw
0;))6OLGHRQHZDVKHUĭ
over threaded end of screw M6 X 10 (FF) and screw on
cap nut (GG) loosely. Repeat procedure to complete
the assembly of all four sections. Fully tighten all of
the screws in the rolled edge.
x 9
x 9
x 9
:DVKHUĭ
Screw M6 X 10
B
GG
EE
FF
A
Cap nuts
10-2
TT
GG
EE
FF