Garden Sun Heater HSS-RS-GH Bullet - Manual (Page 8)

8
ASSEMBLY INSTRUCTIONS
Hardware Used
HH
II
JJ
7
TT
7 . WARNING:Remove protective cover before
assembling.
Note: If necessary for proper alignment of reflector
sections, loosen each bolt prior to further assembly
and retighten after sections are aligned.
8. Slide two reflector panels together.
Insert one screw M6 X 10 (II). Slide one washer Φ 6
(HH) over threaded end of screw M6 X 10 (II) and
screw on cap nut (JJ) loosely.
9. Slide reflector plate onto reflector panels.
Insert one screw M6 X 10 (II). Slide one washer Φ 6
over threaded end of screw M6 X 10 (II) and screw on
cap nut (JJ) loosely. Repeat procedure to complete
the assembly of all four sections. Fully tighten all of
the screw s in the rolled edge.
x 9
x 9
x 9
Washer Φ 6
Screw M6 X 10
B
JJ
HH
II
A
Cap nuts
TT
JJ
HH
II
8
9