E-flite UMX Yak 54 180 BNF - Manual (Page 12)

12
EN
Power Components Service
Disassembly
CAUTION: DO NOT handle the propeller
while the fl ight battery is connected to the ESC.
Personal injury could result.
Propeller
1. Remove the screw (A), and propeller (B) from
the prop adapter (C).
Motor
NOTICE: Removing tape or decals can damage
paint on your aircraft. Avoid pinching or otherwise
damaging any wires when opening or closing
the fuselage.
1. Cut through the tape and decals on the
fuselage, then remove the upper fuselage.
2. Disconnect the motor wire connector from
the ESC/receiver connector on the right side
of the fuselage.
3. Inside the fuselage, remove the screw (D) and
motor (E) from the motor mount.
4. Remove 3 screws (F) and the prop adapter (G)
from the motor. The motor magnet may attract
screws to the motor.
Assembly
Assemble in reverse order.
• Connect the motor wire connector to the ESC/
receiver.
• Connect the top and bottom half of the
fuselage with clear tape.
• The propeller size numbers (5.75 x 2.25) must
face out from the motor for correct propeller
operation.
• Ensure the propeller adapter and motor mount
are fully connected to the motor.
A B
C
G
F
E
D