E-flite UMX F4U Corsair RTF with AS3X - Manual (Page 12)

12
EN
To remove the factory-installed landing gear:
1. Lift the end of the landing gear wire above the
stop.
2. Gently pull the landing gear toward the center
of the wing and away from the clips.
Install in reverse order, making sure the end of
the landing gear wire is inside the stop and the
vertical strut is toward the front of each wing.
1
2
Landing Gear Removal
Post Flight Checklist

1. Disconnect the fl ight battery from the ESC
(Required for safety and battery life).
2. Power OFF the transmitter.
3. Remove the fl ight battery from the
aircraft.
4. Recharge the fl ight battery.

5. Store the fl ight battery apart from the
aircraft and monitor the battery charge.
6. Make note of the fl ight conditions and
fl ight plan results, planning for future
fl ights.