E-flite UMX Habu S DF180m BNF - Manual (Page 4)

4
EN
SAFE ™ Transmitter Setup
Your DSM2/DSMX transmitter will need to be confi gured using the provide transmitter setup chart in order
to experience all the features and benefi ts of the receiver with SAFE
™ in this aircraft.
Quick Overview
• SAFE Flight mode is selected using Channel 5 signal (high, middle, low).
• Panic mode is selected with Channel 6 signal (high, low). Refer to your transmitter’s manual for detailed
information on how to navigate through your transmitter settings.
IMPORTANT: A transmitter with a 2-position channel 5 switch will only allow the use of position 0 or
position 2 fl ight modes.
Computerized Transmitter Setup
(DX6i, DX6, DX7S, DX8, DX9, DX10t and DX18)
Start all transmitter programming with a blank ACRO model (do a model reset), then name the model.
Set Dual Rates to:
HIGH 100% LOW 70%
Set Servo Travel to: 100%
DX6i
1. Go to the SETUP LIST MENU
2. Set MODEL TYPE: ACRO
3. Set REVERSE:
Gear Channel
4. Go to ADJUST LIST MENU
5. Set TRAVEL ADJ: Gear/Fmode (0) 100%, Gear/Fmode (1) 40%
6. Set FLAPS: Norm 100, LAND 100
7. Set MIX 1:
ACT; Gear Gear ACT, RATE D 0%; U + 100%, SW MIX, TRIM INH
Resulting in:
The Gear and Mix switches operate the 3 SAFE modes.
Gear 0; Mix 0 = Beginner Mode
Gear 1; Mix 0 = Intermediate Mode
Gear 1; Mix 1 = Experienced Mode
The Flap switch operates Panic Recovery: Position 0=Off
Position 1=On. (not a momentary switch)
DX7S
DX8
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set SWITCH SELECT: Change all to INH: Then TRAINER: AUX1
Then FLAP: GEAR
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse AUX1
Resulting in:
Flap/Gyro Switch operates the 3 SAFE modes.
0 = Beginner Mode
1 = Intermediate Mode
2 = Experienced Mode
The Trainer/Bind button operates Panic Recovery
DX6
DX9
DX10t
DX18
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set WING TYPE: NORMAL
4. Go to CHANNEL ASSIGN: Channel Input Confi g:
Set
GEAR: D (DX10t: GEAR: A)
Set AUX1: I (DX10t: AUX1: R-TIP)
5. Go to the FUNCTION LIST
6. Set SERVO SETUP: Reverse AUX1
Resulting in:
Switch D (DX10t: A) operates the 3 SAFE modes.
0 = Beginner Mode
1 = Intermediate Mode
2 = Experienced Mode
The Bind/I button (DX10t: R-TIP) operates Panic Recovery
IMPORTANT: After you set up your model, always rebind the transmitter and receiver to set the desired
failsafe positions.