E-flite UMX Gee Bee R2 BNF - Manual (Page 13)

13
EN
Service of Power Components
Disassembly
CAUTION: DO NOT handle propeller parts
while the fl ight battery is connected. Personal
injury could result.
Propeller
1. The front of the cowling covers the battery
compartment. Lift the cowling to access the
battery compartment.
2. Carefully remove the screw (A) and the
propeller (B) from the motor shaft (C).
Motor and Firewall
1. Remove 2 screws (D), the firewall (E) and
the motor (F) from the fuselage motor
mount (G).
The motor magnet may attract screws
to the motor.
2. Remove the screw (H) from the firewall (E)
and motor (F).
3. Disconnect the motor wire connectors
from the ESC/receiver connectors.
Assembly
Motor and Firewall
1. Connect the motor wire connectors to the
ESC/receiver connectors so the wire
colors align.
2. Install the motor in the firewall using a screw
in the top of the firewall.
3. Attach the firewall to the fuselage motor mount
using 2 screws.
Propeller
1. Install the propeller on the motor shaft using a
screw.Numbers on the propeller must face out
from fuselage for correct propeller operation.
2. Put the foam battery hatch on the fuselage and
slide it back to fully engage the fuselage.
B
A
C
D
E
F
G
H
E
F
Removing tape or decals may remove paint from
the fuselage.