E-flite Mini Ultra Stick ARF Programming Guide - Manual (Page 5)

says something other than ON, press the select key to make the arrow point at SW, and press the
increase key until it says ON.
To set up the second mix, we will use program mix 4. Enter program mix 4. Press the increase key
until the first channel says FLAP. Then press the select key to make the arrow point at the second
channel, and then press the increase key until the second channel says GEAR. Press the select key until
the arrow points at OFFSET. Press the decrease key until it says –50 next to OFFSET. Press the select
key until the arrow points at RATE, then flap the flap switch into the LAND position, then press the
increase key until the percentage says +60% (adjust this percentage as necessary to get the ailerons to
move as “spoilers” ¾” up, keeping in mind that the value of this program mix must by double the value
and opposite of the value in the previous mix, program mix 3). Next to SW on the screen it should say
ON. If it says something other than ON, press the select key to make the arrow point at SW, and press
the increase key until it says ON.