E-flite Edge 540QQ 280 BNF Basic - Manual (Page 13)

13
EN
Service of Power Components
A
B
Disassembly
CAUTION: Always disconnect the battery
before handling or adjusting the propeller
or motor. Failure to do so could result in
personal injury.
Propeller
1. Remove the 2 screws (A) from the spinner (B).
Carefully separate the spinner from the back
plate (C).
2. Remove the lock nut (D) from the propeller
shaft (E), then remove the propeller (F) and
back plate.
Motor and Firewall
1. Carefully remove the cowling (G) from the
fuselage. Paint may hold the cowling on the
fuselage.
2. Loosen the setscrews (H) and remove the
washer (I) before removing the propeller shaft
from the motor (J).
3. Remove the 4 screws (K) and motor mount (L)
from the fuselage.
4. Disconnect the motor wires from the ESC.
5. Loosen the setscrews (M) and remove the
motor from the motor mount.
6. Assemble in reverse order.
Assembly Tips
• Correctly align and connect the motor wire
colors with the ESC wires.
• The propeller size numbers (6.8 x 3.5) must face
out from the motor for correct propeller operation.
• Ensure the spinner is fully connected to the
spinner back plate for safe operation.
A
B
D F C E
G H I J
K L M
M