Bissell LIFT-OFF 53Y8 - Manual (Page 8)

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
8
Brush roll reset:
if larger debris becomes lodged in the
foot of the unit and the brush roll shuts
off, turn the unit off and remove the
obstruction. Wait approximately 15 sec-
onds for the motor to cool down before
turning back on. brush will function
again after allowing time to cool down.
Brush roll belt replacement:
if the brush roll belt should break,
call 1-800-237-7691 or visit WWW.
bissell.coM to purchase replacement
belt.
Replacement instructions:
1.
Turn power OFF (O). Remove foot
assembly from unit and turn over to access
the brush roll belt.
2. Remove three Phillips head screws to
remove the belt cover.
3. Locate broken belt.
4. Replace belt.
5.
Place brush roll back into foot of unit.
6. Replace the belt cover and secure with
three screws.
7. Attach foot assembly on unit.
disposal of batteries
if your lift-off floors & More is to be
disposed of, the batteries should be
removed and disposed of properly.
1. iMPoRtant: Unplug Charger.
2. Remove hand vac from unit and remove
dirt cup from handle.
3. Remove (5) Phillips head screws on the
handle and cover.
WaRning:
This product contains Nickel Metal Hydride (NiMH)
rechargeable batteries. According to Federal and State
regulations, removal and proper disposal of NiMH bat-
teries is required. For removal of the batteries in your
Lift-Off Floor & More see instructions below.
brush roll and brush roll belt maintenance continued
TM
3.
5 screws
2.
3.