B&K AV5000 User Manual
Page 11

Page 9
If a source other than a B&K series preamplifier is used to control multiple amplifiers,
only the control output voltage from the source is critical. It must be within the range, as
indicated on the rear panel, 5-24 volts DC is required. The amplifier will provide each
successive amplifier with a control voltage of 12 volts DC for reliable operation. The
amplifiers control output may be used as a source of 12 VDC @ 125 mA for other user
applications as well.
If the control function is desired, each unit in the system must remain connected at all
times and the control must be enabled. To enable the control function, the CTRL
ENABLE button must be out for each controllable amplifier in the system. For more
information on the amplifiers output status under various control conditions, refer to the
following table.
@ CTRL IN
Button position
Output status
@ CTRL OUT
Signal
OUT
Sound
Signal
Signal
IN
Sound
Signal
No Signal
OUT
Mute
No Signal
No Signal
IN
Sound
Signal
- ST1400M (16 pages)
- AVR 707/705 (12 pages)
- AVR305 (84 pages)
- CT610 (12 pages)
- FIVE OR SEVEN CHANNEL 125.7 S2 (12 pages)
- CT300.3 (2 pages)
- 5 S2 (20 pages)
- AVR202 Series (52 pages)
- AVR517 (64 pages)
- AVR315 (88 pages)
- 200.1 S2 (12 pages)
- AV2500 Series II (20 pages)
- 7250 (16 pages)
- ST140M (16 pages)
- PT 3 series II (36 pages)
- EX4420M (15 pages)
- ST1400 (14 pages)
- CT310 (88 pages)
- 4420M (16 pages)
- AVR505 (88 pages)
- TX4430 (15 pages)
- 200.5 S2 (12 pages)
- CT600.1 (88 pages)
- Reference 70 HT 70 (12 pages)
- VMR-6.5.4 (12 pages)
- P/N13445 (16 pages)
- AVR507 SERIES 2 (64 pages)
- AVR212 (88 pages)
- AV5125 (16 pages)
- AV6125 (16 pages)
- ST1200 Series (20 pages)
- 3220 (16 pages)
- REF 70 (2 pages)
- ST3140 (16 pages)
- Reference 4430 (16 pages)
- 220M (16 pages)
- AVR202 Plus (84 pages)
- ST260 (20 pages)
- AVR202 Series (60 pages)
- AVR707 (2 pages)
- 2220 (16 pages)
- series II (16 pages)
- AV2600 (16 pages)
- ST2140 (16 pages)