Hinkley Lighting BURIAL BALLAST BOX 53000 - Manual (Page 2)

mounting instructions
Family: 120V Series Large Burial Box Item No. 53000 BZ
Drawing 2 - Fixture Mounting
1. Use Mastic (E) to seal the conduit entries from inside wire compartment (F) to ensure
the sealant (G) does not flow down the conduit - see DRAWING 2.
2. Push wire nut connections (H) to the bottom of the wiring compartment.
3. Remove sealant pouch from protective cover (C). Grasp both sides of sealant pouch
(G) and pull until there is no barrier between both solutions in the pouch.
4. Mix the sealant (G) by alternately squeezing each end of sealant pouch, moving the
sealant back and forth until solutions are completely mixed together.
5. Cut corner of the sealant pouch (G) and immediately pour into wiring compartment
covering the wire nuts (H).
6. Allow sealant to dry (approximately 20 minutes).
7. Replace silicone gasket and cover (C) and tighten screws (4) evenly.
8. Supply power to the ballast box and check for proper operation.
9. Please refer back to the front of this sheet to install lamp and complete the
installation of this fixture.
1
D
3 4
2
H
G
E
F
WARNING: TO REDUCE THE
RISK OF FIRE, OR INJURY
TO PERSONS:
1. Turn off/unplug and allow
to cool before replacing lamp.
2. Lamps get hot quickly!
Contact only switch/plug
when turning on.
3. Do not touch hot lens,
guard or enclosure.
4. Keep lamp away from
material that may burn.
5. Do not operate luminaire
fitting with a missing
or damaged cover.