Braun L955 - Manual (Page 19)

Page 17
Pre-Lift Operation Notes and Details
Fully-Engaged Roll Stop Latch
Latch Foot
Fully-Folded
(Up-vertical)
Roll Stops
Fully-Unfolded (Ramp position) Roll Stops
Disengaged
Roll Stop
Latch
B C
Outboard Roll Stop: When the
platform lowers fully to ground
level, the roll stop cylinder
compression spring automati-
cally unfolds (rotates) the roll
stop to the ramp position (fully
unfolded). See photos A and B.
Although the outboard roll stop
is lift-powered, the activation of the roll stop is controlled by the
lift operator. Activating either
DOWN switch unfolds the roll
stop. The roll stop is cylinder-
powered to automatically fold
(rotate) to the vertical position
when the UP switch is activated
(roll stop raises before platform
raises). Side Entry Roll Stop: When
the platform lowers fully to
ground level, the spring-loaded
side entry roll stop unfolds
(rotates) to the ramp position
simultaneously with the out-
board roll stop (when DOWN
switch is activated). See photos
A and B. The belt and chain
2"
Note: The platform must raise
approximately two inches
before the latch engages fully.
L955U: The roll stop
latch is on opposite
side of the platform.