Bushnell SCOUT VIEWER 1-Nov User Manual

Page 15

TWO-Year LIMITED WARRANTY
Your Bushnell

product is warranted to be free of defects in materials and workmanship for

two years after the date of purchase. In the event of a defect under this warranty, we will, at our

option, repair or replace the product, provided that you return the product postage prepaid.

This warranty does not cover damages caused by misuse, improper handling, installation, or

maintenance provided by someone other than a Bushnell Authorized Service Department.

Any return made under this warranty must be accompanied by the items listed below:

1) A check/money order in the amount of $10.00 to cover the cost of postage and handling

) Name and address for product return

) An explanation of the defect

) Proof of Date Purchased

) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit,

with return postage prepaid to the address listed below:

IN U.S.A. Send To:

IN CANADA Send To:

Bushnell Outdoor Products

Attn.: Repairs

00 Marshall Drive

A East Pearce Street, Unit 1

Lenexa, Kansas 1

Richmond Hill, Ontario LB M

For products purchased outside the United States or Canada please contact your local dealer

for applicable warranty information. In Europe you may also contact Bushnell at:

BUSHNELL Performance Optics Gmbh

European Service Centre

MORSESTRASSE

D- 0 KÖLN

GERMANY

Tél: + (0) 1 0

Fax: + (0) 1 0

This warranty gives you specific legal rights.

You may have other rights which vary from country to country.

FCC Note:
This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 1

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or

more of the following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment and receiver.

· Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

· Consult the dealer or an experienced radio/TV

technician for help.

Shielded interface cable must be used with the equipment

in order to comply with the limits for a digital device

pursuant to Subpart B of Part 1 of FCC Rules.

Specifications and designs are subject to change without

any notice or obligation on the part of the manufacturer.