Hide-a-Hose Central vacuum system - Manual (Page 2)

TO RETRAcT ThE hOSE:
Attach
appropriate
cleaning tools
and vacuum.
Close
the
door.
Open the
door and
pull out the
amount of
hose you
need.
Place the
locking
mechanism
into the
locked
position.
2 ways to turn
the vacuum on:
Option 1 - Use
the low voltage
switch at the
inlet. 1
2
3
4
TO OpERATE:
1
2
3
4
5
6
With the power
unit still on, bring
the hose back to
the area near the
inlet valve.
Leave the
vacuum
running and
disconnect
the handle.
Move the
locking
mechanism to
the unlocked
position.
Regulate the retraction
speed of the hose by placing
the palm of your hand over
the end of the hose, until it
retracts itself completely into
the valve.
Turn the system off after the hose
is returned completely into the
valve. If you turn the
unit on with the RF
handle, you must turn
the unit off with the
RF handle. If you turn
the unit on with the
low voltage switch,
you must turn the
unit off with the
low voltage switch.
Option 2 - Use the
RF handle. Hold the
switch in the “on”
position until you
hear the vacuum,
and/or air flow. Then
let go of the switch.
(Note: You will feel the hose stop when you get to the
end. If the hose comes completely out of the wall, simply
reinsert the hose several inches back into the inlet.)
(Note: The locking mechanism prevents the hose
from retracting while you vacuum.)