Clay Paky SUPERSHARPY (C61390) - Manual (Page 10)

10 SUPERSHARPY
SET UP MENU
DMX ADDRESS
PLEASE NOTE: Without the DMX input signal, the displayed address (DMX Address) blinks.
It lets you select the address (DMX Address) for the control signal. A DMX address between 001 and 512 can
be selected.
CHANNEL MODE
This lets you select the projector operating mode, selecting one of the two available modes:
x Standard (23 DMX channels occupied, see Channel Function)
x Vector (27 DMX channels occupied, see Channel Function)
FIXTURE ID
It lets you set the “Fixture ID” to be assigned to the projector. An “ID” between 000 and 255 can be assigned.
ETHERNET INTERFACE
It lets you set Ethernet settings to be assigned to the projector as indicated below:
Control Protocol
It lets you select the “Control Protocol” Art-net to be assigned according to the control unit used; the options
available are the following:
x Disabled:
x Art-net on IP 2
x Art-net on IP 10
Repeat on DMX
It lets you enable/disable the transmission of the Ethernet protocol by DMX signal to all the connected
projectors.
x Disabled: DMX transmission disabled.
x Enabled on primary: DMX transmission enabled.
Universe
It lets you set the “DMX Universe” to be assigned to a series of projectors with values between 000 and 255.