Clay Paky A.LEDA B-EYE K20 (C61420) - Manual (Page 13)

13 A.LEDA B-EYE
DISPLAY
Used for automatically reduce brightness on the display after about 30
seconds in idle.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to enable (On) or disable (Off)
the decreasing of display brightness.
3) Press F to confirm the selection or LEFT D to keep current settings.
FAN SPEED MODE
Allows you to set how to manage the fan speed of the head of the fixture,
select between the two available:
• Auto: the head’s fan varies the speed depending on the temperature
detected on the LED.
• Full: the head’s fan is always at full speed.
SPECIAL FUNCTIONS
Pan / Tilt speed
Lets you select two different Pan and Tilt speeds.
1) Press
F - the current setting appears on the display.
2) Use the UP B and DOWN C keys to select one of the following settings:
- Normal
- Fast
3) Press F to confirm the selection or LEFT D to keep current settings.
Dimmer Curve
Lets you select four different Dimmer channel curves.
1) Press
F - the current setting appears on the display.
2) Use the UP B and DOWN C keys to select one of the following
settings:
- Curve 1
- Curve 2
- Curve 3
- Curve 4
3) Press F to confirm the selection or LEFT D to keep current settings.
RGB Gamma
Lets you select three different RGBW gamma curves.
1) Press
F - the current setting appears on the display.
2) Use the UP B and DOWN C keys to select one of the following settings:
- Gamma 1.0
- Gamma 1.5
- Gamma 2.0
3) Press F to confirm the selection or LEFT D to keep current settings.
Halogen Mode
Lets you select five different halogen lamp simulations.
1) Press
F - the current setting appears on the display.
2) Use the UP B and DOWN C keys to select one of the following
settings:
- Halogen OFF
- Halogen Lamp 1 - 750 W
- Halogen Lamp 2 - 1000 W
- Halogen Lamp 3 - 1200 W
- Halogen Lamp 4 - 2000 W
- Halogen Lamp 5 - 2500 W
3) Press F to confirm the selection or LEFT D to keep current settings.
SETTING
Used to save 3 different settings of the items in the options menu and
relative submenus.
1) Press
F - “Default preset” appears on the display.
2) Use the UP B and DOWN C keys to select one of the following
configurations:
- Default preset (*)
- User preset 1
- User preset 2
- User Preset 3
3) Press F - “Load preset X” appears on the display.
4) Use the UP B and DOWN C keys to select:
- Load preset X to recall a previously stored configuration.
- Save to preset X to store the current configuration.
a confirmation message (Are you sure?) appears on the display.
5) Select YES to confirm the selection or NO to keep the current setting
and return to the next higher level.
(*) DEFAULT PRESET
Save To
Preset 3
Reset To
Dafault
Go Back
Setting
Default
Preset
Load
Preset 1
Save To
Preset 1
User
Preset 1
Load
Preset 2
Save To
Preset 2
User
Preset 2
Load
Preset 3
User
Preset 3
Dimmer
Curve
RGB
Gamma
Halogen
Mode
Special
Functions
Pan / Tilt
speed
On
Off
Display
Auto
Full
Fan Speed
Mode
Continue ➔