Calculated Industries 6020-E v3.0 - Manual (Page 12)

12 – Scale Master ® Classic v3.0
4) Press [Rcl] [M2x]. This displays the
linear value stored in this register.
Press [M2x] a second time to calculate
and display the area. Press the [M2x]
key again to find volume. Press [M2x]
a fourth time to display the stored
height value.
Converting Between Scales
The Scale Master Classic can automati-
cally convert values between scales.
For example, 20 feet rolled in 1/16”
scale will be converted to 10 feet in
1/8” scale. You may want to roll a
value in one scale and then add that
exact value (unconverted) in another
scale.
1) Roll a value and press [M1+]. Press
[Scale] to change scales.
2) Roll another value and press [M1+].
3) Press [Rcl] [M1+] to recall the
combined total.
Locking Scale Settings
Your Scale Master Classic comes
equipped with a lock switch that pre-
vents inadvertently changing drawing
scales. When the lock is activated, a
lock symbol will be displayed in the
LCD. While active, the Scale and Mode
cannot be revised (other than by
removal of the battery).
(Cont’d)