Calculated Industries 4094 Pocket Reference Guide - Manual (Page 14)

enTerinG dimensions
linear Dimensions
When entering feet-inch values, enter dimen-
sions from largest to smallest — feet before
inches, inches before fractions. Enter fractions
by entering the numerator (top number),
pressing  (Fraction Bar key) and then the
denominator (bottom number).
Note: If a denominator is not entered, the
fractional setting value is used.
Examples of how linear dimensions are entered
(press  after each entry):
DImENSIoNS KEySTRoKES
5 feet  
5 feet, 1 ½ inches

     
17.5 meters

7   
1250 millimeters

    
Square and cubic Dimensions
Examples of how square and cubic dimensions
are entered (press  after each entry):
DImENSIoNS KEySTRoKES
14 square inches    
11 square feet    
3.3 square meters     
3 cubic feet    
4094-Inside Pages_Corrected.indd 14 4/27/2009 10:21:01 AM