brite-View LinkE Mini BV-5100 User Manual - Manual (Page 11)

11
*NOTE: It does not matter which device’s button is pressed first, but please press the second device’s GROUP
button within two minutes after pressing first device’s GROUP button. After 10 seconds, device will start
communicating with device A.
4.2 Remove Device from an Existing Network Group
If you would like to remove powerline device from an existing network group, you can generate a new
group name (referring to Step I) to stop communication with an existing network group.
4.3 Create Additional Private Network
If you want to create additional private network for your powerline devices that co-existence with your
existing powerline private network group, please repeat the Step 1 & 2 to generate new private network
group for selected powerline devices.
P.S. Users can press the RESET button to reset the network name back to its factory default.
4.4 Standby Mode
Standby mode enables the powerline device to save power consumption. The device automatically enters
standby if no Ethernet cable is connected, or the PC connecting this device enters standby, hibernation, or
powered-off over two minutes. During standby, only POWER LED blinks at slower rate. To exit standby,
just insert the Ethernet cable to the device, or wake up the connecting PC.
Note:
Some computers support Wake up LAN function that may cause our PLC can’t enter the standby mode.