Bissell SPOT LIFTER 1718 series - Manual (Page 6)

WATER
FORMULA
Charging the battery
1. When charging for the first time, allow to charge
uninterrupted for at least 12 hours.
nOTE: When charging, the Spot Lifter and
charger may become warm to the touch.
This is normal and no cause for concern.
2. Spot Lifter must be in “
O
” (OFF) position
to charge.
3. When completely charged, your Spot Lifter
will operate for up to 7 minutes for model 1718
and up to 15 minutes for model 1719. When
completely discharged, it will take approximately
12 hours to fully recharge.
4. To charge your Spot Lifter, connect the round end
of the charger cord into the power port on the
back of the unit.
nOTE: Decreased operating time may
indicate that the battery has built up a
charging resistance. To recharge, first
completely exhaust the battery, recharge
it, then exhaust it once again before
recharging a second time. This procedure
may be required more than once.
Filling the solution tank
1. Remove solution tank by grasping it firmly and
pulling straight up.
2. Unscrew and remove the cap. Add water and
formula* to the indicated fill lines on the solution
tank.
*note: your Spot Lifter includes a trial
size bottle of 2X formula.
3. Replace cap and place solution tank back on unit.
O
perations
1.
6
Formula Fill Line
Tip:
For maximum battery life, completely
discharge and recharge Spot Lifter
every 1-2 months.
Tip:
After unit is charged (approximately
12 hours) unplug from outlet.
This will aid in prolonging the life of
the battery.
Water Fill Line
2.
3.
6
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1