Blomberg GSN 9470 XSP - Manual (Page 9)

8 EN
A
For your safety, close the water
inlet tap completely after the
washing programme is over.
Connection to the drain
Water discharge hose can directly be
connected to the drain hole or sink’s
drainage. The length of this connection
must be min. 50 cm and max. 100 cm
from the floor.
1011
— Open the taps completely after
making the connections to check
for water leaks.
�
��
��
��
��
��
��
��
��
��
���
��
�
���������
����
����������
�������
����
����
There are two different types of
water inlet hoses:
— Cold water inlet hose (up to 25°C)
—
Hot water inlet hose (up to 60°C)
B
Please check which one is
applicable to your model.
B
If you plan to connect your machine
to natural energy resources or to
the central hot water supply, first
check out the temperature values
written on your water inlet hose
to make sure that it is suitable for
such usage. If your hose is not
suitable, apply to your Authorised
Service Agent to have it changed.
—
Do not use old or used water inlet
hose on the new product. Use the
new water inlet hose supplied with
the product.
—
Connect the water inlet hose
directly to the water tap. Pressure
coming from the tap should be
minimum 0.3 and maximum 10
bars. If the water pressure exceeds
10 bars, a pressure relief valve
should be installed in between.
C
Use a screw-on hose connector
to connect the water inlet hose to
a water tap with a ¾ inch external
thread. If required, use a filter
insert to filter deposits from the
pipes.
1009
A discharge hose longer than 4 meters
causes dirty washing.
Attach the water discharge hose
to the drainpipe without bending it.
Tightly fix the water discharge hose to
the drainpipe in order to prevent any
dislocation of the water discharge hose
during operation of the product.