Blizzard Lighting Weather System (Rev A) - Manual (Page 12)

Page 12
Weather System User Manual Rev. A Copyright (c) 2012 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
d001
on the LED
Readout. To select a different DMX address, hit the button and use
the buttons to select the your desired starting DMX address,
then hit again to confirm your choice.
Auto, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable
speeds.
1.) To use the fixture in 7 channel or 26 channel mode, use the
d001
and hit the button. Push the button
again and scroll to either
7-CH or 26CH.
2.) To set the fixture in automatic mode, use the button to scroll to
AU7O
and hit . Use the buttons to scroll through the
auto programs
n001 -n100
and push the button to confirm your
choice. Then you can adjust the chase speed. Use the buttons to
adjust the chase speed setting from
SP 01 - SPFL
(slow <--> fast), and push
the button. Now you can adjust the strobe speed by selecting the
speed adjustment settings of
FS 01 - F599
(slow <--> fast).
3.) To set the fixture to run one of its 22 built-in chase patterns, use the
button to scroll to
Pr--,
and hit . Use the
buttons to scroll through auto program choices of
Pr01 -Pr22
and push the
button to confirm your choice. Then you can adjust the chase speed
of the program by using the buttons and choose from
SP 01
- SPFL
(slow <--> fast), and push the button. Now you can adjust
the strobe speed by selecting the strobe speed adjustment settings of
FS 01 -
F599
(slow <--> fast).
4.) To use the fixture as a slave unit, use the button to scroll to
SLAu
and hit the button. Your fixture will then be in slave mode.
Sound Active Mode:
1.) To use this fixture in sound active mode, scroll to
SU--
using the
button, and hit . Then using the buttons, choose the
built-in sound active chase pattern from
SU01 - SU31
and hit . You
can then adjust the chase speed by using the buttons to adjust
the speed from
SP 01 - SP10
(slow <--> fast).
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture. These settings are global, they
will effect all modes.
1.) Use the button to navigate to
Colr
and hit the button.
2.) From here, you can navigate to
r255, 9255,
or
b255
and use the
DOWN> buttons to adjust the global intensity of red, green, or blue from
000
- 255.