Page 12, D001, Addr – Blizzard Lighting V12 ToughPar (Rev A) User Manual

Page 12: Chnd, Flas or fade, Fl00-fl15, Fa00-fa15, As00-as15, Sp15, Sp00

Page 12

ToughPar V12 Manual Rev. B

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

1.) The default mode for the fixture is DMX, which appears as

d001

on the LED Readout. To

select a different DMX address, using the

button, select

Addr

,then hit .

Use the buttons to select the correct address, then hit to confirm.

Setting the DMX Channel Mode:
1.) To select a DMX channel mode, press the

button, then use the or

buttons until the display reads

Chnd

and press the

button. Then use

the or buttons until the display reaches your desired channel mode. Press
the

button to confirm.

Stand-Alone, Master/Slave, Sound Active Modes:

Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.

1.) To set the fixture in Flash/Fade mode, select

FLAS or FAdE

. To confirm, press the

button.
2.) Now, you can adjust the flash settings from

FL00-FL15

or the fade settings from

FA00-FA15.

Then press the button to confirm.

3.) To use the fixture in automatic mode, select

ASC-

, and press the button. Then

use the to choose from

AS00-AS15

, then press the button to

confirm.
4.) Adjust the speed of the chase as above using

SP15

(slowest) to

SP00

(fastest) then

press the button to confirm.

5.) To set the fixture as a slave unit, select

SLAU

, and hit . The unit will display a

flashing

SL.AU

to indicate it is in slave mode.

Standalone (Program) Mode:

Allows a single unit to display a variety of colors and programs without a DMX controller.

1.) To set the fixture in manual mode, select

Pr--

To confirm, press the button.
2.) Now, select the program by using the and buttons to select

Pr00-

Pr35

. To confirm, press the button.

Manual Color Adjustment:

Allows the user to adjust the color balance of the fixture. These settings are global, they will effect all
modes.

1.) Use the

and button to select

rL--

(Red Level),

GL--

(Green

Level),

bL--

(Blue Level),

AL--

(Amber Level) or

UL--

(White Level), then press the

button to confirm your choice.

2.) Using the buttons, select the maximum level for each color between

x000-

x255

(000=off), then hit to confirm.