Blizzard Lighting RGBAW ToughPAR (Rev B) User Manual

Page 9

Page 9

ToughPAR RGBAW Manual Rev. B

Fixture Linking (Master/Slave Mode)

1. Connect the (male) 3 pin connector side of the

DMX cable to the output (female) 3 pin connector of

the fi rst fi xture.

2. Connect the end of the cable coming from the

fi rst fi xture which will have a (female) 3 pin connec-

tor to the input connector of the next fi xture con-

sisting of a (male) 3 pin connector. Then, proceed

to connect from the output as stated above to the

input of the following fi xture and so on.

A quick note: Often,

the setup for Master-

Slave and Standalone

operation requires that

the fi rst fi xture in the

chain be initialized for

this purpose via either

settings in the control

panel or DIP-switches.

Secondarily, the fi xtures

that follow may also re-

quire a slave setting.

Check the “Operating Adjustments” section in this manual for com-

plete instructions for this type of setup and confi guration.

Mounting & Rigging
This fi xture may be mounted in any SAFE position provided there is

enough room for ventilation.

It is important never to obstruct the fan or vents pathway. Mount the

fi xture using a suitable “C” or “O” type clamp. The clamp should be

rated to hold at least 10x the fi xture’s weight to ensure structural sta-

bility. Do not mount to surfaces with unknown strength, and ensure

properly “rated” rigging is used when mounting fi xutres overhead.

Adjust the angle of the fi xture by loosening both knobs and tilting the

fi xture. After fi nding the desired position, retighten both knobs.

• When selecting installation location, take into consideration lamp

replacement access (if applicable) and routine maintenance.
• Safety cables MUST ALWAYS be used.
• Never mount in places where the fi xture will be exposed to rain,

high humidity, extreme temperature changes or restricted ventilation.