Blizzard Lighting 90 Torrent (Rev A) - Manual (Page 8)

Page 15
Torrent 90 Manual Rev. A Copyright (c) 2010-11 Blizzard Lighting, LLC
12
000 <-> 005
006 <-> 127
128 <-> 189
190 <-> 193
194 <-> 255
Prism
Prism Out
Prism In
Prism Rotation Clockwise (Fast <-> Slow)
Stop
Prism Rotation Counter-Clockwise (Slow <-> Fast)
13 000 <-> 191
192 <-> 223
224 <-> 255
Iris
Out to In (Maximum Diameter <-> Minimum Diameter)
Pulse (Opening, Fast <-> Slow)
Pulse (Closing, Slow <-> Fast)
14 000 <-> 255
Pan/Tilt Speed
Fast <-> Slow
15
000 <-> 019
020 <-> 039
040 <-> 059
060 <-> 079
080 <-> 099
100 <-> 119
120 <-> 139
140 <-> 159
160 <-> 179
180 <-> 199
200 <-> 219
220 <-> 239
240 <-> 255
Control (Hold Each for 5 Seconds to Set)
Normal Color Change Mode
Split Colors Possible (Color Wheel will not snap to a color)
Split Colors & Gobos Possible (Wheels will not snap)
No Function
Motor Reset
Internal Program #1
Internal Program #2
Internal Program #3
Internal Program #4
Internal Program #5
Internal Program #6
Internal Program #7
Internal Program #8
DMX Channel Values (Continued)
Page 16
Torrent 90 Manual Rev. A Copyright (c) 2010-11 Blizzard Lighting, LLC
Troubleshooting
Symptom Solution
Fixture Auto-
Shut Off
Check the fan in the fi xture. If it is stopped or moving
slower than normal, the unit may have shut itself off due to
high heat. This is to protect the fi xture from overheating.
Clear the fan of obstructions, or return the unit for service.
Beam is Dim Check optical system and clean excess dust/grime. Also
ensure that the 220V/110V switch is in the correct position,
if applicable.
No Light Output Check to ensure fi xture is operating under correct mode, IE
sound active/auto/DMX/Etc., if applicable. Contact service
for more information.
Chase Speed
Too Fast/Slow
Check to ensure proper setup of speed adjustment.
No Power Check fuse, AC cord and circuit for malfunction.
Blown Fuse Check AC cord and circuit for damage, verify that moving
parts are not restricted and that unit’s ventilation is not
obstructed
Slow Movement Verify that 220V/110V switch is in the correct position, if
applicable. Also check that speed channels are set appropri-
ately.
No Response to
Audio
Verify that the fi xture is in “Sound Active” mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not
Responding /
Responding Er-
raticly
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fi xture(s).
Intermittant
Lamp
Check lamp for properly installation.
Relamp, lamp may have reached end of life.
Remote Doesn’t
Work
Verify remote control cable is installed properly and securely.
Verify remote is correct type (CA-9 or other as applicable.)
Fixture Moving
On Its Own
Verify proper mode of operation. Is the fi xture in “Auto”
mode?
If your problem isn’t listed, or if problems persist,
please contact support: [email protected].