Blizzard Lighting RGBAW (CP) The Puck (Rev B) - Manual (Page 7)

Page 7
Puck Couch Potato RGBAW Manual Rev. B Copyright (c) 2013 Blizzard Lighting, LLC
Figure 3: The Remote Control
Black Out
Auto Mode
Value Up
Master Dimmer (Press & Hold)
Values: (000-255)
Sound Active
Fade Mode
Value Down
Adjust Speed
of Auto/Fade
(1-8)
Built-In
Colors (1-9)
& Set DMX
Address
Red (000-255)
DMX Address
(Hold for 2
Seconds)
Amber (short
press) or White
(long press)
000-255
Green (0-255)
Set DMX
Channel Mode
(Hold for 2
Seconds)
Blue (0-255)
Note: You must first synchronize the remote control with the fixture.
1. Press the
Addr
, and
then press the button for 5 seconds. The digital display then shows
rFrt
,
accompanied by flashes. Then point the remote control at the infrared receiver in the front
of the fixture and press any button. The remote is now synchronized to control the fixture.
(Each fixture can store up to three remote control codes)
2. Clear the remote code: press the
Addr , then press for 5 seconds, the digital display then shows
rFrt
, then
press the
3. To set DMX address: Push the remote control key 5 seconds, and the digital
display will show
Addr
(flashing), then press the number keys to enter the address code
you wish to use, or use the <+/-> buttons to scroll through your choices.
4. To select a DMX channel mode: Push the remote control key 2 seconds, and the
digital display will show
ChNd
(flashing), then press the number keys <1>, <2>, or <3>
to select from the 3 different channel modes, or use the <+/-> buttons to scroll through
your choices.
5. You can set R/G/B/A/W colors with the remote by pushing either the Red button for
red, the Green button for green, and the Blue button for blue. Push the black
button quickly for amber, and push and hold the same button for 5 seconds
for white. Each color’s intensity is then adjustable using the <+/-> buttons (0-255).
Note: Make sure to point the remote control directly at the receiver on the
product which is on the front of the unit.
Color Mode