Operating adjustments, Addr, Chnd – Blizzard Lighting Q6A The Puck (Rev C) User Manual
Page 10: Slnd, Nast, Slau, Stby, Soun, Sou1, Sou2
Page 10
The Puck Q6A / Q6W Manual Rev. C
Copyright (c) 2011-12 Blizzard Lighting, LLC
4. OPERATING ADJUSTMENTS
NOTE: After making any adjustment, hold the
3 seconds, otherwise the fixture will return to the correct mode after approxi-
mately 10 seconds.
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
Addr
on the LED
Readout. Use the
choose a channel between
1
and
512
. Press
2.) To change between 4 and 7 channel DMX mode, select
ChNd,
then press
7Ch
or
4Ch
, then press
firm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX con-
nector on the rear of the units.
2.) Choose a unit to function as the Master. Select MAST. The master unit must
be the first unit. Finally, chain the units together using DMX cable.
Master
SLNd
then
NASt
to confirm.
3.) Select slave function by using the
the Master/Auto menu on the slave units, and they will react in the same as the
Master.
Slave
SLNd
then
SLAu
to confirm.
NOTE: Fixtures in slave mode will display “
STBY
“ (Standby). This is NORMAL.
Return the fixture to master mode to use it as a standalone fixture.
4.) On the master fixture, use the
allows you to select the Master/Slave mode.
Use the
SOUN
to choose from either of two
different sound active modes.
Sound active 1: Scenes will fade slowly when there is no audio present:
Sou1
then
Sound active 2: Fixture blacks out when there is no audio present:
Sou2
then
Auto mode
CoLo
then
Auto,
then
Color preset
CoLo
then
CoL 1 - CoL 15,
Fade Mode
FAdE
then
SP 1 - SP 8,
NOTE: Speed 1 = Fastest (Approx. 1.5 sec. per color), Speed 8 = Slowest (Approx.
2 min. per color).